Complex leaching of metal-sulfide-containing mine waste and soil in microcosms

Emese Vaszita, János Szabó, Katalin Gruiz

Research output: Contribution to journalArticle

6 Citations (Scopus)

Abstract

Complex leaching, as a site-specific process, was modelled in four laboratory soil microcosms in order to follow and quantify potential metal emissions (Gruiz et al. 2006) and metal transport along the soil-groundwater pathway in an abandoned base-metal sulfide ore mining area in the Mátra hills in Northern Hungary. Mine-waste rock and soil samples, collected from the abandoned mining site at Gyöngyösoroszi, were tested in the four microcosms, where the effect of the average annual rainfall was simulated, with allowance for evaporation. Water was added manually by irrigation to the surface of each microcosm at pre-arranged time intervals. The water addition rate was estimated, based on the average annual rainfall (756 mm/m2/year) and evaporation data for the area provided by the Hungarian Meteorological Service (OMSZ 2002). The experiment started more than five years ago and is still running. Three main conditions are studied at successive time intervals: (a) the initial phase of the complex leaching process, reproducing the average annual rain conditions; (b) the dry-weather conditions phase, with one-third of the average annual rain-water input; (c) the metal-depletion phase of the complex leaching process, showing sulfide depletion of the leached mine waste at two-thirds of the average annual rain-water input. The four microcosms simulate two scenarios: (1) bioleaching within a large waste dump in two replicate microcosms containing only mine waste (M1, M2); and (2) bioleaching in a mine-waste dump in contact with the surrounding soil in two other replicate microcosms, containing mine waste on top of a thin soil layer (T1, T2). The waste material and the soil were analysed for total (aqua regia extract) and mobile metal (NH4OAC + AcOH + EDTA extract) content at the start of the experiment. The quantity and quality (pH, As, Cd, Cu, Pb and Zn content) of the output leachates from each microcosm were measured at regular time intervals. The temperature within the microcosms was monitored. The cell concentration of the sulfide-oxidizing bacteria, Acidithiobacillus ferrooxldans, was measured (Sand er al. 2007). Results of the microcosm experiment were interpreted, based on the following: (a) input leachant and output leachate volumes; (b) cell concentration of the sulfide-oxidizing bacteria and pH of the leachates; (c) metal concentration of the leachates; and (d) metal concentration of the mine-waste and soil samples in the microcosms at the start of the experiment. The microcosm experiment provided site-specific quantitative parameters for risk assessment and risk-reduction planning, with the aim of reducing metal emissions from the point and diffuse sources in the area (Gruiz et al. 2006b).

Original languageEnglish
Pages (from-to)463-471
Number of pages9
JournalLand Contamination and Reclamation
Volume17
Issue number3-4
DOIs
Publication statusPublished - Dec 1 2009

    Fingerprint

Keywords

  • Acid rock/mine drainage
  • Environmental-risk assessment
  • Leaching
  • Metal sulfides
  • Microcosm experiment

ASJC Scopus subject areas

  • Water Science and Technology
  • Geotechnical Engineering and Engineering Geology
  • Environmental Science(all)

Cite this