Comparative analysis of machining procedures

Janos Kundrak, Viktor Molnar, Istvan Deszpoth

Research output: Contribution to journalArticle

3 Citations (Scopus)

Abstract

The in-depth analysis of cutting procedure is a topic of particular interest in manufacturing efficiency because in large-scale production the effective use of production capacities and the revenue-increasing capacity of production are key conditions of competitiveness. That is why the analysis of time and material removal rate, which are in close relation to production, are important in planning a machining procedure. In the paper three procedures applied in hard cutting are compared on the basis of these parameters and a new parameter, the practical parameter of material removal rate, is introduced. It measures not only the efficiency of cutting but also that of the whole machining process because it includes the values measured by time analysis as well. In the investigations the material removal rate was analyzed, first on the basis of geometrical data of the component. After that different machining procedures (hard machining) were compared for some typical surfaces. The results can give some useful indications about machining procedure selection.

Original languageEnglish
Article number13
JournalMachines
Volume6
Issue number2
DOIs
Publication statusPublished - Jun 2018

    Fingerprint

Keywords

  • Combined procedure
  • Grinding
  • Hard turning
  • Material removal rate
  • Operation time

ASJC Scopus subject areas

  • Computer Science (miscellaneous)
  • Control and Systems Engineering
  • Mechanical Engineering
  • Control and Optimization
  • Industrial and Manufacturing Engineering
  • Electrical and Electronic Engineering

Cite this